Justfired up ACC for the first time. My Fanatec CSL Elite was not detected at all, so I installed fresh Fanatec drivers. That fixed the detection, and I set the wheel up, it shows the wheel rotating etc. When I launch the game though the wheel will not steer. The buttons work. The pedals work. The gears shift. But no steering. Any ideas?
July2020 edited July 2020 Hi, I decided to play ACC after a long time and, to my surprise, my FANATEC V2.5 base wheel with V3 pedals are not being recognized by2 Select The Recommended Game Controller Layout (Game Library Settings) 3. In-game under Controls Select Xbox360/Controller 4. Go To Practice Run (Select Gamer Tab Mode for testing) 5. Click Start Engine Button 6. Game will load and Steam should load the correct config 7. Enjoy this worked for my luna controller, it mightAssettoCorsa reproduces this "self-steer" with a steering wheel controller with force feedback. However, gamepads do not have FFB. Makes Assetto Corsa not only playable on controller, but the best racing game you can play with a gamepad. Stellar job! Upvote 0 Downvote. RAD_AP; 5.00 star(s) Apr 27, 2023; Atthe bottom of the pedals tab there is an option that reads 'Enable CSL Elite Pedals LC manual mode'. After you click on that, pull the Handbrake once. Afterwards, while the lever is depressed click on 'Min' on the handbrake section. With the lever completely pulled click on 'Max'. Nowhere in the process was it required to calibrate the InCM you go to Settings -> Assetto Corsa -> Controls and you get the assignment page. On the lower right part of the screen you see 4 buttons, the one on the Ive not played ACC much, but it was working fine with a screen. I have my wheel and Reverb G2 working perfectly with AC and iRacing. When I load ACC in VR mode I get as far as the Steam room and it tells me that I need wither a game controller or a mouse and keyboard to play - needless to say, I have a mouse and keyboard. v41MCCS.